me in front of the drax unit.. its a daunting wall of shit right now.. i work on her piece by piece and hopefully it will all go fairly smooth.. i have a general idea of how it should go so. the pic of the aluminum is the armiture that holds all the boards and sub boards for the unit. this goes over top of the pots and switches in the faceplate. and sits about 1.5 inches or so away in parallel. i have to make this hinge so i can then access the pots and such when and if there will be repairs/adaptations and issues. so then the rear enclosure has a hinge and then the main board assembly will have a hinge as well. just seems like wise plan..the overlay DSVC is the extra 2 row expander module im make ing for this as well.. it extremely simple compared to the drax.. i didnt have the overlay printed i did it on the injet at home.. and seemed it and then sealed it with mylar from the art sore on both sides (3m super 77 spray adhesive wont ruin the clear overlays!!!) the next pic is the actual face plate of the DSVC on the drill press.. i work onthat as time allows as well. i make a simple black and white print out of it with all registration marks for all holes and then rubber cement that to the faceplate and puch drill from there. it gets things like 95% where they should be... ith minimal filing afterwards. so if you want to do it .. try it it that way! the last pic is the cr-8000 switches takes apart for cleaning and such.. they are super delicate and basicly what happens is the carbon comes off the top of the plunger and wont make contact to complete the circiut. so you clean it with a qtip and deoxit d5 and then shave a soft lead pencil for the lead shavings. chop it real fine and then apply it and rub it into the tiny foam pads on the plunger.. it works awesomely and pretty much indefinetely.
No comments:
Post a Comment